Preparation
14
VQT0R81
Inserting/Removing the Battery
• Check that the camera is turned off.
• Close the flash.
1 Slide the release lever in the
direction of the arrow to open the
battery door A.
• Please be sure to use genuine
Panasonic batteries (CGR-S006A).
2 Insert:
Insert the charged battery until it
clicks.
Remove:
Slide the lock B to remove the
battery.
3 1 Close the battery door.
2 Slide the release lever as far as
it will go in the direction of the
arrow to close the battery door
firmly.
• If you will not be using the camera for a
long time, remove the battery.
• When a fully charged battery has been
inserted for more than 24 hours, the clock
setting is stored (in the camera) for at
least 3 months even if the battery is
removed. (The storing time may be
shorter if the battery is not charged
sufficiently.)
If more than 3 months has passed, the
clock setting will be lost. In this case, set
the clock again. (P20)
• Do not remove the card and the battery
while the card is being accessed. The
data on the card may be damaged.
(P16)
• Do not remove the battery with the
camera turned on since the settings on
the camera may not be stored properly.
• The supplied battery is designed only
for the camera. Do not use it with any
other equipment.
O
P
E
N
C
L
O
S
E
O
P
E
N
C
L
O
S
E
O
P
E
N
C
L
O
S
E
To Next Page
Loading...
Need help?
General
