Application (Record)
Taking pictures with Auto Focus
VQT5B87
- 99 -
■
Changing the position and size of the AF area
When [AF Mode] is set to [ ] (1-area-focusing), you can change the position or size of
the AF area at the centre.
If you performing any of the following operations, the screen will switch to the settings
menu.
• When [ ] is selected, press [FOCUS].
• From the menu screen, select [ ], and press .
To change the AF area
To move the AF area: Press
To change the size of the AF area: Rotate the rear dial
• To restore the AF area to its initial state (position and
size) → Press [DISP.] button
Press [MENU/SET]
●
The AF area position and size are stored in the memory even when the camera is
turned off.
●
AF area cannot be moved during motion picture recording.
●
When the AF area is small, it may be difficult to adjust the focus.
●
When [Metering Mode] is set to [ ] (spot-focusing), the new position of the AF area
will be measured.
●
The position and size cannot be changed in [Miniature Effect] of [Creative Control]
mode.
To Next Page
Loading...
