135
Recording
Applicable modes:
Adjust the flash brightness when pictures taken with the flash are over or underexposed.
1 Select [Flash] in the [Rec] menu. (P38)
2 Touch [Flash Adjust.].
3 Set the flash output by dragging the slide bar, and then touch [Set].
•
You can adjust from [j2 EV] to [i2 EV] in steps of [1/3 EV].
• Select [n0] to return to the original flash output.
• [i] or [j] is displayed on the flash icon in the screen when the flash level is adjusted.
• It can be set only when [Wireless] in [Flash] is set to [OFF]. (P135)
Applicable modes:
You can separately control flash-firings of the built-in flash and each flash in three groups
by using the flash that supports the wireless control (DMW-FL360L: optional).
1
Configure the external flash setting to RC mode, and then place the external flash.
• Set the channel and group of the external flash.
2 Select [Flash] on the [Rec] menu. (P38)
3 Select [Wireless] and then touch [ON].
•
When [Wireless] is set to [ON], [WL] is displayed on the flash icon on the recording
screen.
• When making detailed settings of the wireless flash, set the following from [Flash].
[Wireless Channel]
Select the channel that corresponds to the channel of the external flash you want to
control.
Settings: [1CH]/[2CH]/[3CH]/[4CH]
[Wireless FP]
During wireless recording, an external flash fires an FP flash (high speed repetition of flash
firing). This firing allows recording with the flash at a fast shutter speed.
Settings: [ON]/[OFF]
[Communication Light]
Set the communication light level for wireless recording.
Settings: [HIGH]/[STANDARD]/[LOW]
Adjust the flash output
Setting the wireless flash
Preparations: Open the flash of this unit by pressing flash open button.
To Next Page
Loading...
