166
Recording
• When the burst speed is set to [SH] or [H] (when [Focus Mode] is [AFS] or [MF]), the exposure
and White Balance are fixed at the settings used for the first picture for the subsequent pictures
as well. Depending on the brightness of the subject, the second picture and subsequent
pictures may be brighter or darker. When the burst speed is set to [H] (when [Focus Mode] is
[AFF] or [AFC]), [M] or [L], they are adjusted each time you take a picture.
• Since the shutter speed becomes slower in dark places, the burst speed (pictures/second) may
become slower.
• Depending on the operating conditions, it may take time to take the next picture if you repeat
the recording of pictures.
• It may take time to save pictures taken in Burst Mode on the card. If you take pictures
continuously while saving, the maximum number of recordable pictures decreases. For
continuous shooting, use of a high speed memory card is recommended.
Not available in these cases:
•
The Burst Mode is disabled in the following cases.
–[Glistening Water]/[Glittering Illuminations]/[Soft Image of a Flower] (Scene Guide Mode)
–[Miniature Effect]/[Soft Focus]/[Star Filter]/[Sunshine] (Creative Control Mode)
–In Self Portrait Mode.
–When White Balance Bracket is set
–When recording motion pictures
–When recording using the flash
–When [HDR] is set to [ON]
–In [Stop Motion Animation] (only when [Auto Shooting] is set)
• In the following cases, [SH] in Burst Mode cannot be used.
– When [Quality] is set to [ ], [ ] or [ ]
–In [Stop Motion Animation]
To Next Page
Loading...
