131
5. 4K Photo and Drive Settings
Selecting a focus point after recording
([Post Focus])
Applicable modes:
The camera can perform Burst recording in the same picture quality as 4K photo recording
while automatically shifting the focus to different areas. After the recording, you can select
the desired area on the screen and save a picture in which the selected area is in focus.
This function is suited for recording still objects.
•
Use a UHS Speed Class 3 card. (P28)
• When using [Post Focus], the angle of view is narrower.
1 Press [ ].
2 Press 2/1 to select [ON] and press [MENU/SET].
•
It can also be set by going to the [Rec] menu and selecting [ON] for [Post Focus].
3 Decide on the composition, and press the shutter
button halfway.
•
Auto Focus will detect focus areas on the screen.
(Excluding the edges of the screen)
• If no areas on the screen can be brought into focus, the
focus display (
A
) will flash. Recording is not possible in
this case.
4 Press the shutter button fully to start recording.
•
The focus point changes automatically while recording.
When the icon (
B
) disappears, recording automatically
ends.
• A motion picture in MP4 format will be recorded. (Audio will not be recorded.)
• When [Auto Review] is enabled, a screen that lets you select the desired focus area will
be displayed. (P133)
4K burst recording while
automatically shifting the
focus.
Touch the desired focus
point.
A picture with the desired
focus point is made.
Recording using [Post Focus]
From the time you press the shutter button halfway until the end of recording:
• Maintain the same distance to the subject and the same composition.
• Do not operate the zoom. (Otherwise, recording will not be performed or will stop.)
5HFRUGLQJLQSRVWIRFXV
5
m
04
s
To Next Page
Loading...
Need help?
General
