45
2. Getting Started/Basic Operations
Temporarily changing the items assigned to the front/rear dials ([Dial Operation
Switch])
You can temporarily change the items assigned to the front/rear dials using the function
button to which [Dial Operation Switch] is assigned.
•
You can set the items to be assigned temporarily to the front/rear dials in [Dial Operation Switch
Setup] in [Dial Set.] in the [Custom] menu. (P46)
1 Set a function button to [Dial Operation Switch]. (P58)
•
The following step is an example in which [Dial Operation Switch] is assigned to [Fn1].
2 Press [Fn1].
•
A guide will be displayed showing the items temporarily
assigned to the front/rear dials.
• If no operations are performed, the guide will disappear in
a few seconds.
3 Rotate the front/rear dials while the guide is
displayed.
•
The settings of the items assigned to the dials will change.
4 Press [MENU/SET] and set.
•
You can also complete this step by performing either of the operations below:
– Press the shutter button halfway
– Press the rear dial
– Press [Fn1]
• Items that are temporarily assigned to the front/rear dials can be used only while the guide
(step
2) or setting screen (step 3) is displayed.
989898
0
ISOISOISOISO
WBWBWBWB
AWB
To Next Page
Loading...
