Others
123
13: The picture does not appear on
the television.
13-1: Is the camera connected to the TV
correctly?
Check it.
13-2: Set the TV to video input mode.
14: When connecting to a PC,
pictures cannot be transferred.
14-1: Is the camera connected to the PC
correctly?
Check it.
14-2: Is the camera recognized by the
PC correctly?
14-3: Is the USB mode set correctly?
15: The clock setting is reset.
15-1: If you do not use the camera for a
long time, the clock setting may be
reset. When the message
[PLEASE SET THE CLOCK]
appears, set the clock again.
15-2: When you take a picture before
setting the clock, [0:00 0. 0. 0] is
recorded.
16: Some pixels are inactive or
always lit on the LCD monitor.
16: This is not a malfunction. These
pixels do not affect the recorded
pictures.
17: The pictures cannot be printed
with printers supporting USB
Direct-Print or PictBridge.
17: Is the USB mode set correctly?
18: When there are bright parts on
the subject, a vertical red
spectrum may appear on the
screen.
18: This is called smear. It is specific
to CCD, not a malfunction. It is
recorded on motion images, but
not recorded on still pictures.
19: The stripe is displayed on the
screen.
19: It does not affect the recorded
pictures.
20: The camera may chatter when it
is turned on or off.
20: This is not a malfunction. This is
caused by opening or closing the
aperture.
LC1PP.book 123 ページ ２００４年１月２６日 月曜日 午後６時５０分
To Next Page
Loading...
