Preparation
14
Using the AC Adaptor
You can use the camera without worrying about battery discharge by connecting to
an AC adaptor.
Preparation
• Check if the camera is turned off.
• Close the flash.
1 Connect the AC cable.
2 Slide the terminal door to open.
3 Connect the DC cable.
¬
Suggestions/Tips
¬
• Use the supplied DC cable.
If you use other DC cables, it may
cause a malfunction.
• The camera becomes warm during
use. This is not a malfunction.
• Disconnect the AC adaptor and DC
cable when the camera is not in use.
• The battery cannot be charged in the
camera even if the AC adaptor is
connected.
LC1PP.book 14 ページ ２００４年１月２６日 月曜日 午後６時５０分
To Next Page
Loading...
Need help?
General
