Recording pictures (basic)
51
Taking Pictures using Burst Mode
Preparation
• Set the operational mode dial to burst mode [ ]. (P30)
1 Select [BURST RATE], set [ ]
or [ ] and then take pictures.
• Keep pressing the shutter button
fully to activate the burst mode.
• Close the menu by pressing the
[MENU] button after finishing the
setting.
¬
Suggestions/Tips
¬
ª Burst speed
ª Number of pictures recorded in
burst mode
• When the flash is not activated, it is
possible to record 2.7 frames in 1
second in burst mode at a shutter
speed higher than 1/60th.
• If the flash is activated, you can record
only 1 frame.
• You cannot take pictures with audio in
the burst mode.
• When setting auto bracket and the
burst mode simultaneously, auto
bracket will be performed.
• Burst mode will not perform as
described if a MultiMediaCard is used
in place of an SD Memory Card. The
reading/writing speed of a
MultiMediaCard is slower than that of
an SD Memory Card.
• When setting the quality to [ ], you
cannot take pictures in the burst mode.
• When you slow the shutter speed,
the shutter may be kept closed after
recording due to the signal
conditioning. This is not a
malfunction. The burst interval also
becomes longer and the limit on the
burst frames is released.
• The number of remaining frames may
not correspond with recorded frames.
• If you rotate the zoom ring while taking
pictures in the burst mode, recorded
pictures may not be correctly focused
on the subject.
Burst speed
2.7 frames/
second
1 frame/
second
Picture
size
2560
max.
3 frames
max.
5 frames
max.
9 frames
2048
max.
5 frames
max.
8 frames
max.
15 frames
1600
max.
8 frames
max.
15 frames
max.
28 frames
H
L
MENU
SPOT AF
SENSITIVITY
BURST RATE
AUDIO REC.
SETUP
SELECT SET EXIT
MENU
REVIEWREVIEW
REC
2
/
4
H L
1280
max.
12 frames
max.
23 frames
max.
44 frames
640
max.
44 frames
max.
80 frames
max.
137 frames
HDTV
max.
8 frames
max.
14 frames
max.
27 frames
RAW
LC1PP.book 51 ページ ２００４年１月２６日 月曜日 午後６時５０分
To Next Page
Loading...
Need help?
General
