Preparation
20
Attaching the Strap
1 1 Pressing both sides of the
cover.
2 Pull out the black strap holder
completely.
2 Detach the black strap holder from
the metal fitting.
• When the black strap holder is
completely detached, attach it
again as above.
3 Pass the metal fitting through the
eyelet of the camera.
4 Rotate the black strap holder in
the opposite direction until it
clicks.
5 Slide the cover until it is attached
firmly.
• Attach the strap to the other side of the
camera being careful not to twist it.
• Attach the strap so that you can see
“L
UMIX” logo.
• Check if the strap is firmly attached to
the camera.
LC1PP.book 20 ページ ２００４年１月２６日 月曜日 午後６時５０分
To Next Page
Loading...
Need help?
General
