Recording pictures (basic)
46
: Forced OFF
Even in dark places, the flash is not
activated.
Use this when taking pictures in
places where use of the flash is not
allowed.
• Refer to P72 for setting the 1st and
2nd curtain.
ª Available flash settings
¢When setting to the 2nd Curtain
Synchro, flash setting is not available.
ª The available flash range to take
pictures
• Refer to P37 for the focus range.
ª Adjusting flash output
Adjust the flash output when the subject
is small or reflection ratio is extremely
high or low.
1 Press [ ] until
[ FLASH] appears on the
screen to set the flash output.
• You can adjust this from j2EV to
i2 EV in steps of 1/3 EV.
• The determined flash output is
memorized even if the camera is
turned off.
ª Bounce Flash
Bounce flash is a technique which
reflects the light from the flash to ceiling
or a wall.
When you directly illuminate the front of
the subject, dark shadows may appear
±±±j
±° ±° ±° j
±±±±
±° ±° ±° ±°
±±jj
±° ±° j j
±±±±
ISO
sensitivity
Available flash range
ISO AUTO
1.64 feet
(50 cm) – 15.8 feet
(4.8 m) (Wide)
1.64 feet
(50 cm) – 13.1 feet
(4 m) (Tele)
ISO100
1.64 feet
(50 cm) – 15.8 feet
(4.8 m) (Wide)
1.64 feet
(50 cm) – 13.1 feet
(4 m) (Tele)
ISO200
2.3 feet
(70 cm) – 22 feet
(6.7 m) (Wide)
2.3 feet
(70 cm) – 18.4 feet
(5.6 m) (Tele)
ISO400
3.3 feet (1 m) – 31.2 feet
(9.5 m) (Wide)
3.3 feet (1 m) – 26.3 feet
(8 m) (Tele)
SET
FLASH
REVIEW
REVIEW
LC1PP.book 46 ページ ２００４年１月２６日 月曜日 午後６時５０分
To Next Page
Loading...
Need help?
General
