Playback (advanced)
97
ª When using Windows 2000 Professional, Windows Me, Windows 98/98 SE
or Mac OS 9.x
• When connecting the camera to a PC, do not set [USB MODE] to [PTP].
(When the camera is shipped, [Mass Storage] is selected.)
• When using [Mass Storage] on Windows 98/98 SE, install the USB driver before
connecting. (When using Windows Me/2000/XP, Mac OS 9.x and Mac OS X, you
do not have to install the USB driver.)
• When connecting to a PC which includes the
above-mentioned OS and when setting the [USB MODE] to
[PTP], the messages shown on the right appear on the LCD
monitor of the camera.
The following messages appear for each OS on the display of the PC. Select
[Cancel] to close the window and disconnect the USB connection cable.
PTP
USB MODE
OS Message
Windows 2000 Professional [Welcome to the Found New Hardware
Wizard]
Windows Me
Windows 98/98 SE
[New Hardware Found]>
[Add New Hardware Wizard]
(When you connect to the PC more than
2 times, only [Add New Hardware Wizard]
appears.)
Mac OS 9.x [Software needed for the USB device
“DMC-LC1” is not available. Would you like to
look for the software on the Internet?]
LC1PP.book 97 ページ ２００４年１月２６日 月曜日 午後６時５０分
To Next Page
Loading...
