- 120 -
Wi-Fi
To display picture on a TV wirelessly
• The Wi-Fi connection setup screen is displayed if you have not done the Wi-Fi setup yet.
Follow the on-screen instruction to configure.
Preparation: Set the TV to DLNA waiting Mode.
•
Read the operating instructions for your TV.
Select [Wireless TV Playback] in the [Wi-Fi] menu. (P41)
• If you have already set the connection destination, the confirmation screen is displayed. Select [Yes]
to display pictures stored in this unit on TV.
• Press 2/1 to play back the previous/next picture.
• Press [ ] to quit [Wireless TV Playback].
∫ To change the connection destination
1 Press [DISP.] on the destination confirmation screen.
2 Press 3/4 to select the item, and press [MENU/SET].
∫ To change the wireless access point
1 Press [DISP.] on the destination confirmation screen.
2 Press 3/4 to select [Change Access Point], and press [MENU/SET].
3 Press 3/4 to select a name of registered wireless access point or [New Access
Point], and press [MENU/SET].
•
When you select [New Access Point], a new access point will be registered to this unit.
Note
•
Motion pictures cannot be displayed.
To Next Page
Loading...
Need help?
General
