EasyManuals Logo

Panasonic Lumix DMC-ZR3 User Manual

Panasonic Lumix DMC-ZR3
377 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #208 background imageLoading...
Page #208 background image
Others
- 174 -
[MOTION RECORDING WAS CANCELLED DUE TO THE LIMITATION OF THE
WRITING SPEED OF THE CARD]
Use a card with SD Speed Class
with Class 4” or higher when recording motion pictures in
[AVCHD Lite].
Also, use a card with SD Speed Class with “Class 6” or higher when recording motion pictures
in [MOTION JPEG].
SD Speed Class is the speed standard regarding continuous writing.
In the event that it stops even after using a “Class 4” card or higher, the data writing speed has
deteriorated so it is recommended to make a backup and then format (P30).
Depending on the type of the card, motion picture recording may stop in he middle.
[THIS CARD IS NOT FORMATTED WITH THIS CAMERA, AND NOT SUITABLE FOR
MOVIE RECORDING.]
The writing speed is lower if the card has been formatted using a PC or other equipment. As a
consequence, motion picture recording may stop in the middle. If this happens, make a
backup of the data and format (P30) the card in this unit.
[CANNOT RECORD DUE TO INCOMPATIBLE FORMAT(NTSC/PAL) DATA ON THIS
CARD.]
This card is for a different recording format, so cannot be used. Save the data on the card to a
PC, and use the card after formatting it with this unit.
[A FOLDER CANNOT BE CREATED]
A folder cannot be created because there are no remaining folder numbers that can be used.
(P156)
Format the card after saving necessary data on a PC etc. (P30) If you execute
[NO.RESET] in the [SETUP] menu after formatting, the folder number is reset to 100.
(P27)
[PICTURE IS DISPLAYED FOR 16:9 TV]/[PICTURE IS DISPLAYED FOR 4:3 TV]
The AV cable is connected to he camera.
Press [MENU/SET] if you want to delete this message at once.
Select [TV ASPECT] in the [SETUP] menu if you want to change the TV aspect. (P28)
This message also appears when the USB connection cable is connected to the camera only.
In this case, connect the other end of the USB connection cable to a PC or a printer. (P154,
157)
[PRINTER BUSY]/[PLEASE CHECK THE PRINTER]
The printer cannot print.
Check the printer.
[NO BATTERY POWER REMAINS]
The remaining battery power is low.
Charge the battery.
[THIS BATTERY CANNOT BE USED]
The battery cannot be recognized by the camera.
Use a genuine Panasonic battery. If this message is displayed even when a genuine
Panasonic battery is used, contact the dealer or your nearest Service Center.
The battery cannot be recognized as its terminal is dirty.
Remove any dirt etc. from the terminal.

Table of Contents

Other manuals for Panasonic Lumix DMC-ZR3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Panasonic Lumix DMC-ZR3 and is the answer not in the manual?

Panasonic Lumix DMC-ZR3 Specifications

General IconGeneral
BrandPanasonic
ModelLumix DMC-ZR3
CategoryDigital Camera
LanguageEnglish

Related product manuals