Advanced (Recording pictures)
- 60 -
[REC] Mode: ·¿
Taking Pictures Using Auto Bracket
In this mode, 3 pictures are automatically recorded in the selected exposure
compensation range each time the shutter button is pressed. You can select the picture
with the desired exposure from the 3 pictures with different exposures.
With Auto Bracket 1EV
Note
•
When setting Auto Bracket, [ ] appears on the screen.
• When taking pictures using Auto Bracket after setting the exposure compensation range, the
pictures taken are based on the selected exposure compensation range.
When the exposure is compensated, the exposure compensation value appears on the lower
left of the screen.
• The Auto Bracket setting is canceled if you turn the camera off or [SLEEP MODE] is activated.
• When Auto Bracket is set, the Auto Review function is activated regardless of the Auto Review
setting. You cannot set the Auto Review function in the [SETUP] menu.
• The exposure may not be compensated with Auto Bracket depending on the brightness of the
subject.
• [Œ] is set for the flash when Auto Bracket is set.
• Burst is canceled when Auto Bracket is set.
• Setting of the auto bracket cannot be performed in following conditions.
– In [TRANSFORM], [PANORAMA ASSIST], [HI-SPEED BURST], [FLASH BURST],
[STARRY SKY], [PIN HOLE], [FILM GRAIN] and [PHOTO FRAME] in Scene Mode
– When recording motion pictures
1st picture 2nd picture 3rd picture
0EV 1EV 1EV
Press [È] several times until [AUTO BRACKET]
appears, set the compensation range of the
exposure with /.
• When you do not use Auto Bracket, select [OFF] (0).
Press [MENU/SET] to finish.
• You can also press the shutter button halfway to finish.
To Next Page
Loading...
Need help?
General
