- 43 -
Basic
Extended Optical Zoom mechanism
When you set the picture size to [ ] (3 million pixels), the 14M (14.1 million pixels) CCD
area is cropped to the center 3M (3 million pixels) area, allowing a picture with a higher
zoom effect.
Note
•
The Digital Zoom cannot be set when õ or ¨ has been selected.
• The indicated zoom magnification is an approximation.
• “EZ” is an abbreviation of “Extended Optical Zoom”.
• The Optical Zoom is set to Wide (1) when the camera is turned on.
• If you use the Zoom function after focusing on the subject, focus on the subject again.
• The lens barrel extends or retracts according to the zoom position. Take care not to interrupt
the motion of the lens barrel while the zoom lever is rotated.
• When using the Digital Zoom, [STABILIZER] may not be effective.
• When using the Digital Zoom, we recommend using a tripod and the self-timer (P58) for taking
pictures.
• [I.RESOLUTION] is fixed to [i.ZOOM] in Intelligent Auto Mode, Scene Mode
or Clipboard
Mode.
[i.ZOOM] cannot be used when in [HIGH SENS.], [HI-SPEED BURST], [FLASH BURST] or
[PIN HOLE] in Scene Mode.
• The Extended Optical Zoom cannot be used in the following cases:
– In Macro Zoom Mode
– In [TRANSFORM], [HIGH SENS.], [HI-SPEED BURST], [FLASH BURST], [PIN HOLE] or
[PHOTO FRAME] in Scene Mode
– When recording motion pictures
• [DIGITAL ZOOM] cannot be used in the following cases:
– In [TRANSFORM], [HIGH SENS.], [HI-SPEED BURST], [FLASH BURST], [PIN HOLE],
[FILM GRAIN] or [PHOTO FRAME] in Scene Mode
To Next Page
Loading...
Need help?
General
