Mini VRF SYSTEM
Remote Controller Functions
5 - 19
2. Detailed Settings Function
5
(Continued from previous page)
Item code Item Description
3C
Heat exchanger temperature for
cold air discharge
The heat exchanger temperature control point for prevention of cold air
discharge during heating operation can be changed.
3d Fan output switching
The indoor unit PCB optional output for the fan can be switched
according to the purpose of use.
3E Drain pump delayed stop time
The drain pump stops after the set time delay after cooling operation
stops.
40 Humidifier drain pump setting This specifies the humidifier and drain pump setting.
45 DC flap operation mode Changes flap operation to draft reduction mode.
46 DC flap swing mode Selects the swing operation mode for the flap.
5d DC fan tap setting
Sets the DC fan tap according to the purpose of use.
Change the settings data at the same time.
5E Humidifier ON time
Sets the humidifier output ON time for when the humidifier is operating.
ON/OFF control is performed during humidifier operation.
This setting therefore sets the ON time per 60-second interval.
5F
Stop at time set for OFF timer after
operation starts
This setting enables a function that stops operation when the amount
of time set for the OFF timer has passed after remote controller
operation was started.
60 Timer function change prohibit
This function prohibits changes from being made to the remote
controller time setting.
62 Smudging control Smudging control is disabled when 0000 is set.
SM830289-01_欧州向け R32 mini VRF 8,10HP SM&TRSM.indb 19SM830289-01_欧州向け R32 mini VRF 8,10HP SM&TRSM.indb 19 2021/05/07 10:16:202021/05/07 10:16:20
To Next Page
Loading...
