Panasonic NV-HD90 - Programming the Video Plus+ Pluscode

Programming the Video Plus+
PlusCode
Programming is now easler than ever: simply enter the
PlusCode provided In the programme schedule column
carried by newspapers and magazines.
PlusCodes are numbers which are assigned to each
programme listed in the TV programme schedule carried in
newspapers and TV guides, When these codes are entered
and TRANSMIT is pressed, the codes are converted Into
the actual programming and sent to the VTR.
Timer Recording”
Preparation
elnsert a cassette tape with an intact erasure prevention
Set the programme positions on both the VTR and remote
controller as shown on pages 16~-17.
Operations Display Symbols
1 Open the door of the remote controller.
DON OOF
2 Press VIDEO PLUS+.
mey
3 Enter a PlusCode.
Example: 920216
4 Press CONFIRM to check that the code
corresponds to the right programme. ~
couery
(ean) eC a a
woe gin gel
To make any altenations, use buttons
Vanced Over,
5 Press TRANSMIT. i
Tease
The VTR will be in Timer recording standby mode.
G Close the door of the remote controller.
Notes:
To select the desired tape speed, press RECORDING
SP/LP in any of steps 3-4.
- .. ¢When the PlusCade is used for programming, the
recording time may be slightly longer than the actual
programme time,
*Repeat steps 2 to 4 if "Err appears on the display of the
remote controller.
When programming two or more programmes. repeat
steps 2 to 5 alter pressing TRANSMIT.
The procedures for checking and cancelling whatever has
been programmes are the same as for remote contro!
programming. (See page 26.) :
27