Panasonic NV-SD440EG/ - Page 13

Install the Cylinder Rotor Unit so that the inner hole of the Cylinder Rotor Unit fits to the
small projection (D) on top of the Upper Cylinder.
3.
Tighten 2 screws (B).
Fig. S9
4.
Install the Cylinder Stator Unit so that the rear side of the Cylinder Stator C.B.A. is parallel
with the Head Amp Shield.
5.
Tighten 2 screws (A).6.
Confirm the PG SHIFTER ADJUSTMENT with the alignment tape (PAL:
VFJ8125H3F/NTSC: VFM8080HQFP) and adjust it if necessary.
Fig. S10
7.
file:///C|/___________/SVC/s0201030000.html (3 of 4) [23/09/2005 16:28:19]