Repeat steps (1) to (3) until the green and blue crosshatch
patterns merge into a cyan pattern.
8. After the adjustment, reassemble the projector according to the steps 9 through 13 in the section 6.12. "Replacement of LCD
Panel (B)".
7.5. Lighting Area Adjustment
7.5.1. Tools to be used
Service Kit: This kit is composed of 3 extension flexible cables and 4 connector extension cables.
Note:
·
Consult your dealer or Authorized Service Center for the service kit.
7.5.2. Preparation
1. Remove the upper case and the connector cover according to the steps 1 through 2 in the section 6.3. "Removal of A-
P.C.Board".
2. Unscrew the 2 screws.
24
PT-AX200U / PT-AX200E
To Next Page
Loading...
