Chapter 4 Settings — [PROJECTOR SETUP] menu
126 - ENGLISH
[PROJECTOR SETUP] menu
On the menu screen, select [PROJECTOR SETUP] from the main menu, and select an item from the sub-
menu.
Refer to “Navigating through the menu” (x page 77) for the operation of the menu screen.
[PROJECTOR ID]
The projector has an ID number setting function that can be used when multiple projectors are used side by side
to enable simultaneous control or individual control via a single remote control.
1) Press as to select [PROJECTOR ID].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[ALL] Select this item when controlling projectors without specifying an ID number.
[1] - [64] Select this item when specifying an ID number to control individual projector.
Note
f To specify an ID number for individual control, the ID number of a remote control must match the ID number of the projector.
f When the ID number is set to [ALL], the projector will operate regardless of the ID number specied during remote control or computer
control.
If multiple projectors are set up side by side with IDs set to [ALL], they cannot be controlled separately from the projectors with other ID
numbers.
f Refer to “Setting ID number of the remote control” (x page 75) for how to set the ID number on the remote control.
[PROJECTION METHOD]
Set the projection method in accordance with the installation status of the projector.
Change the projection method if the screen display is upside down or inverted.
1) Press as to select [PROJECTION METHOD].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[FRONT/FLOOR] When installing the projector on the desk, etc., in front of the screen
[FRONT/CEILING] When installing the projector in front of the screen using the Ceiling mount bracket (optional)
[REAR/FLOOR] When installing the projector on the desk, etc., behind the screen (with a translucent screen)
[REAR/CEILING]
When installing the projector behind the screen (with a translucent screen) using the Ceiling mount
bracket (optional)
[LAMP SELECT]
Select the lamp to be lit from the four built-in luminous lamps according to the use conditions or purposes.
1) Press as to select [LAMP SELECT].
2) Press qw to switch the item.
[L1] Lamp 1 will light.
[L2] Lamp 2 will light.
[L3] Lamp 3 will light.
[L4] Lamp 4 will light.
[L1/L4] Lamps 1 and 4 will light.
[L2/L3] Lamps 2 and 3 will light.
[L1/L2/L3] Lamps 1, 2, and 3 will light.
[L1/L2/L4] Lamps 1, 2, and 4 will light.
[L1/L3/L4] Lamps 1, 3, and 4 will light.
[L2/L3/L4] Lamps 2, 3, and 4 will light.
[SINGLE] One lamp will light. (The lamp with shorter runtime will automatically light.)
[DUAL] Two lamps will light. (The lamps with shorter runtime will automatically light.)
[TRIPLE] Three lamps will light. (The lamps with shorter runtime will automatically light.)
To Next Page
Loading...
