Panasonic PT-DZ21K2

Chapter 4 Settings — [PROJECTOR SETUP] menu
ENGLISH - 137
5) Press as to select [GROUP].
6) Press qw to switch the item.
[A] - [Z]
Controls multiple projectors simultaneously by sending the ID of RS-232C. You can set groups from
[A] to [Z]. The projector responds when the ID of RS-232C matches the setting.
7) Press as to select [RESPONSE(ID GROUP)].
8) Press qw to switch the item.
[ON] Returns the response when an ID is designated as GROUP.
[OFF] Does not return the response when an ID is designated as GROUP.
Note
f When [INPUT SELECT] is set to [DIGITAL LINK], communication using that serial terminal is available only when the corresponding device
(such as the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G)) is connected to the <DIGITAL LINK/
LAN> terminal.
f When transferring logos via the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G), setting for “NO
SIGNAL SLEEP” of the DIGITAL LINK output supported device should be set to “OFF” to avoid interruption of communication.
f When [INPUT SELECT] is set to [DIGITAL LINK], communication speed for input is xed to 9 600 bps and the parity is xed to “NONE”.
[STATUS]
Display the status of the projector.
1) Press as to select [STATUS].
2) Press the <ENTER> button.
f The [STATUS] screen is displayed.
3) Press qw to switch the pages.
f The page will change each time you press the button.
[PROJECTOR TYPE] Displays the projector type and serial number of the projector.
[PROJECTOR RUNTIME] Displays the runtime of the projector.
[LAMP1] Displays the runtime and status of lamp 1.
[LAMP2] Displays the runtime and status of lamp 2.
[LAMP3] Displays the runtime and status of lamp 3.
[LAMP4] Displays the runtime and status of lamp 4.
[INTAKE AIR TEMP.]
*1
Displays the status of the intake air temperature of the projector.
[OPTICS MODULE TEMP.]
*1
Displays the status of the internal temperature of the projector.
[EXHAUST AIR TEMP.]
*1
Displays the status of the exhaust air temperature of the projector.
[COOLING CONDITION] Displays the set cooling conditions.
[ATMOSPHERIC PRESSURE] Displays the atmospheric pressure.
[SELF TEST] Displays the status of the projector.
[INPUT] Displays the input terminal currently selected.
[BACKUP INPUT STATUS]
Displays whether switching to the signal of the backup input is possible or not when [BACKUP INPUT
MODE] is set to [ON] or [1], [2]. (x page 111)
[SIGNAL NAME] Displays the input signal name.
[SIGNAL FREQUENCY] Displays the frequency of the input signal.
[NUMBER OF REGISTERED
SIGNAL]
Displays the number of registered signals.
[REMOTE2 STATUS] Displays the control status of the REMOTE2.
[AC VOLTAGE] Displays the input supply voltage.
[LAMP UNIT MODEL NO.] Displays the model no. of the lamp unit used in the projector.
[LAMP1 SERIAL NUMBER] Displays the serial number of lamp 1.
[LAMP2 SERIAL NUMBER] Displays the serial number of lamp 2.
[LAMP3 SERIAL NUMBER] Displays the serial number of lamp 3.
[LAMP4 SERIAL NUMBER] Displays the serial number of lamp 4.
[MAIN/SUB VERSION] Displays the main and sub versions of the rmware of the projector.