Chapter 4 Settings — [NETWORK] menu
164 - ENGLISH
Item Description
[BRIGHTNESS SENSOR]
There is a problem with the luminance sensor. If problems persist even after switching
on the power, consult your dealer.
[ANGLE SENSOR] There is a problem with the angle sensor. Consult your dealer.
[LAMP DRIVE MODE] There is a problem with the lamp. Consult your dealer.
[FILTER UNIT]
The air lter unit is not attached. Check the connection of the air lter unit.
(x page 181)
r [WARNING] items
Item Description
[INTAKE AIR TEMPERATURE]
The intake temperature is high. The projector may be used in an environment where the
temperature is high, such as near a heating appliance.
[OPTICS MODULE TEMPERATURE]
The temperature around the optics module inside the projector is high. The projector
may be used in an environment where the temperature is high, such as near a heating
appliance.
[EXHAUST AIR TEMPERATURE]
The exhaust air temperature is high. The projector may be used in an environment
where the temperature is high, such as near a heating appliance. Or the air exhaust port
may be blocked.
[LAMP1 REMAIN TIME] The runtime of the lamp has exceeded the specied time, and it is time to replace the
lamp.
[LAMP2 REMAIN TIME]
[LAMP3 REMAIN TIME]
[LAMP4 REMAIN TIME]
[POWER CIRCUIT TEMPERATURE] The temperature around the power circuit is high. The air intake port may be blocked.
[FPGA TEMPERATURE] The temperature inside the projector is high. The air intake port may be blocked.
[BATTERY] Battery replacement is required. Consult your dealer.
[AIR FILTER]
There is too much dust accumulated in the air lter. Set the <MAIN POWER> switch to
<OFF> (x page 64), and clean the air lter. (x page 181)
[AC VOLTAGE]
The input supply voltage is low. Use electric wiring that can sufciently withstand the
power consumption of the projector.
[LOW-TEMPERATURE]
The temperature around the optics module inside the projector is low. Projection cannot
be started until the optics module becomes warm.
[SET THE TERMINALS DOWN] Install with the connection terminals at the bottom.
[USE ONLY THE PORTRAIT LAMP] Use the lamp for portrait mode.
[HORIZONTAL TILT] The projector is used tilted at an angle that exceeds 15° from the horizontal plane.
[LAMP MIX] Different types of lamps are used together. Use the lamps of the same type.
[LIGHT OUTPUT LIMIT]
The projector may be used in an environment where the temperature is high, and this
function is limited to protect the projector.
[NOT SUPPORTED LAMP]
The lamp unit for portrait mode is attached. Replace the lamp unit to that for the
projector.
[Network status] page
Click [Status] → [Network status].
The current network setting status is displayed.
To Next Page
Loading...
