Chapter 4 Settings — [NETWORK] menu
[E-mail set up] page
When there is a problem or the runtime of a lamp reaches a set value, an E-mail can be sent to preset E-mail addresses (up to two
addresses).
→
1
2
3
4
5
6
1 [ENABLE]
[SMTP SERVER NAME]
set up.
3 [MAIL FROM]
in single byte)
4 [MEMO]
Enter information such as the location of the projector that
byte)
[MINIMUM TIME]
E-mail will not be sent for 60 minutes after sending the
temperature warning E-mail even if it reaches the warning
temperature.
6 [INTAKE AIR TEMPERATURE]
8
7
8
7
9
7
8 Settings of the conditions to send E-mail
[MAIL CONTENTS]:
[ERROR]:
[LAMP RUNTIME]:
[INTAKE AIR TEMPERATURE]:
[PERIODIC REPORT]:
Places a check mark on this to send an E-mail periodically.
9