Panasonic PT-FX400U

POSITION menu
46
- ENGLISH
Settings
PT-FX400U
AUTO NORMAL WIDE
REAL H-FIT
S 4:3 FULL V-FIT
Note
AUTO appears only during NTSCz or 480i input.
z
Only specic input signals are projected in REAL
z
mode.
When wide signals *
z
2
are input, the aspect ratio
switches from NORMAL

V-FIT

FULL.
AUTO
J
[Only when NTSC and 525i (480i) signals are
input]
If signals contain a signal identifying the aspect
ratio, the proper ratio is automatically set and the
image is projected.
NORMAL
J
When standard signals *
1
or wide signals *
2
are
input, the image is projected keeping the input
aspect ratio.
Input signal: XGA
z
Image:
Input signal: 1125 (1080)/60i
z
Image:
WIDE
J
When standard signals *
1
are input, the image is
projected with the aspect ratio converted to 16:9.
Input signal: XGA
z
Image:
H-FIT
J
When standard signals *
1
are input, the aspect
ratio is kept xed. The image is projected using
all the panel pixels horizontally, and the vertical
edges of the image are cropped.
Input signal: SXGA
z
Image:
V-FIT
J
When wide signals *
2
are input, the aspect ratio
is kept xed. The image is projected using all the
panel pixels vertically, and the horizontal edges of
the image are cropped.
Input signal: 1125 (1080)/60i
z
Image:
FULL
J
The image is projected using all the panel (screen)
pixels. The input signal are converted to the
aspect ratio of the panel (screen).
Input signal: 1125 (1080)/60i
z
Image:
S4:3
J
When standard signals *
1
are input, the image is
projected with the signal size compressed down to
75 %. (Convenient for projecting an image of 4:3
aspect ratio to a screen of 16:9).
Input signal: XGA
z
Image: Panel: Screen:
Standard signals are signals with 4:3 or 5:4 aspect ratio.*1 :
Wide signals are signals with 16:10, 16:9, or 15:9 aspect ratio.*2 :