Panasonic PT-MZ880

Chapter 4 Settings — [PROJECTOR SETUP] menu
ENGLISH - 123
2) Press the <ENTER> button.
f
The
[SECURITY PASSWORD]
screen is displayed.
3) Enter a security password and press the <ENTER> button.
4) When the confirmation screen is displayed, press
qw
to select [OK], and press the <ENTER> button.
Note
f
The security password is the password set in the [SECURITY] menu
→
[SECURITY PASSWORD CHANGE].
Initial password as the factory default:
awsqawsq
f
The projector enters the standby mode to reect the setting values when [LOAD ALL USER DATA] is executed.
f
Data registered from a computer is not included in [ALL USER DATA].
[HDMI CEC]
Sets the CEC (Consumer Electronics Control) function of HDMI.
CEC is a function that is realized by exchanging device control signals with external devices connected with
an HDMI cable. Using the remote control of the projector, it is possible to operate the CEC-compatible external
device (hereinafter referred to as "CEC-compatible device") and to control the power on/off link status between the
projector and the CEC-compatible device.
For details on how to use the CEC function, refer to “Using HDMI-CEC function” (
x
page 164).
1) Press
as
to select [HDMI CEC].
2) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[ON]
Enables the CEC function.
[OFF]
Disables the CEC function.
Operating a CEC-compatible device
Operate the CEC-compatible device connected to the <HDMI IN 1> terminal, <HDMI IN 2> terminal or <HDMI IN
3> terminal.
[HDMI-CEC OPERATION] can be operated when HDMI1 input, HDMI2 input or HDMI3 input is selected. Switch to
the input that is corresponding to the CEC-compatible device you want to operate in advance.
1) Press
as
to select [HDMI CEC].
2) Press
qw
to select [ON].
3) Press the <ENTER> button.
f
The
[HDMI CEC]
screen is displayed.
4) Press
as
to select [HDMI 1], [HDMI 2] or [HDMI 3].
f
Select the input corresponding to the CEC-compatible device you want to operate.
f
Proceed to Step
6)
when the device to operate is displayed.
5) Press
qw
to switch the item.
f
The devices will switch when multiple CEC-compatible devices are connected to one input.
f
Select the device to operate.
6) Press
as
to select [HDMI-CEC OPERATION].
7) Press the <ENTER> button.
f
The HDMI-CEC operation screen is displayed.
8) Select the item displayed on the HDMI-CEC operation screen to operate the device.
f
Refer to the “Using HDMI-CEC function” (
x
page 164) for the operation details.
Note
f
If no CEC-compatible device is connected to <HDMI IN 1>, <HDMI IN 2> or <HDMI IN 3> terminal, there is no device displayed at [HDMI 1],
[HDMI 2] or [HDMI 3] and [----] is displayed.
f
To exit the HDMI-CEC operation screen, press the <RETURN> button or <MENU> button.