Panasonic PT-MZ880

Chapter 4 Settings — [NETWORK] menu
142 - ENGLISH
4) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[OFF]
Disables the PJLink notication function.
[ON]
Enables the PJLink notication function.
f
If [ON] is selected, proceed to Step
5)
.
5) Press
as
to select [NOTIFIED IP ADDRESS 1] or [NOTIFIED IP ADDRESS 2].
f
Enter the IP address of the computer to notify the status of the projector.
[Art-Net]
Set the Art-Net function.
Setting the password of the administrator account (
x
page 137) is required for using the Art-Net function of the
projector.
Note
f
If the password of the administrator account has not been set, that is, if it is left blank, the network function of this projector cannot be used.
Set a password before using the web control function or the communication control (including operation with application software) via LAN.
[Art-Net SETUP]
Make settings to use the Art-Net function.
1) Press
as
to select [Art-Net].
2) Press the <ENTER> button.
f
The
[Art-Net]
screen is displayed.
3) Press
as
to select [Art-Net SETUP].
4) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[OFF]
Disables the Art-Net function.
[ON(2.X.X.X)]
Enables the Art-Net function and sets the IP address to 2.X.X.X.
[ON(10.X.X.X)]
Enables the Art-Net function and sets the IP address to 10.X.X.X.
[ON(MANUAL)]
Enables the Art-Net function and uses the IP address set in [WIRED LAN].
f
Proceed to Step
5)
when anything other than [OFF] is selected.
5) Press the <ENTER> button.
f
The
[Art-Net SETUP]
screen is displayed.
6) Press
as
to select an item, and press
qw
to switch the setting.
[NET]
Enter [NET] to be used when the projector processes Art-Net.
[SUB NET]
Enter [SUB NET] to be used when the projector processes Art-Net.
[UNIVERSE]
Enter [UNIVERSE] to be used when the projector processes Art-Net.
[START ADDRESS]
Enter [START ADDRESS] to be used when the projector processes Art-Net.
7) Press
as
to select [STORE], and press the <ENTER> button.
f
The conrmation screen is displayed.
8) Press
qw
to select [OK], and press the <ENTER> button.
Note
f
If [ON(2.X.X.X)] or [ON(10.X.X.X)] is selected, IP address is calculated and set automatically.
f
The network setting is common for the <LAN> terminal and the <DIGITAL LINK/LAN> terminal.
[Art-Net CHANNEL SETTING]
Set the assignment of the channel.