Panasonic PT-MZ880

Chapter 7 Appendix — Technical information
ENGLISH - 195
<REMOTE 2 IN> terminal
The projector can be remotely controlled (contact control) by the control board that is located far away form the
projector where the signal from the remote control does not reach.
Use the <REMOTE 2 IN> terminal on the connecting terminals of the projector to connect to the control board.
COMPUTER HDMI3
HDMI1 DIGITAL LINK
HDMI2
Remote control/contact control
Standby Lit
Light source
Remote control
Contact control
Installation locations in meeting rooms, etc.
Remote control board in another location
Pin assignments and signal names
D-Sub 9-pin
Outside view
Pin No. Signal name Open (H) Short (L)
(1) (5)
(6) (9)
(1)
GND ― GND
(2)
POWER OFF ON
(3)
COMPUTER Other COMPUTER
(4)
HDMI1 Other HDMI1
(5)
HDMI2 Other HDMI2
(6)
HDMI3 Other HDMI3
(7)
DLINK Other DLINK
(8)
SHUTTER OFF ON
(9)
RST/SET Controlled by remote control Controlled by external contact
Attention
f
When controlling, make sure to short-circuit pins (1) and (9).
f
When pins (1) and (9) are short-circuited, the following buttons on the control panel and the remote control are disabled. Commands for
RS-232C and network functions corresponding to these functions are also disabled.
g
Power <
v
/
b
> button, <SHUTTER> button
f
When pins (1) and (9) are short-circuited, and then any pins from (3) to (7) and the pin (1) are short-circuited, the following buttons on the
control panel and the remote control are disabled. Commands for RS-232C and network functions corresponding to these functions are also
disabled.
g
Power <
v
/
b
> button, <INPUT SELECT> button, <COMPUTER> button, <HDMI 1> button, <HDMI 2> button, <HDMI 3> button, <DIGITAL
LINK> button, <SHUTTER> button
Note
f
Setting of the pin (2) to pin (8) can be changed when the [PROJECTOR SETUP] menu
→
[REMOTE2 MODE] is set to [USER]. (
x
page 117)