Panasonic PT-MZ880

Chapter 2 Getting Started — Setting up
ENGLISH - 33
Setting up
Installation mode
The installation modes of the projector are as follows. Set [FRONT/REAR]/[FLOOR/CEILING] in the [PROJECTOR
SETUP] menu
→
[PROJECTION METHOD] (
x
page 107) depending on the installation mode.
Setting on a desk/oor and projecting forward Setting on a desk/oor and projecting from rear
(Using the translucent screen)
Menu item Setting value Menu item Setting value
[FRONT/REAR]
[FRONT]
[FRONT/REAR]
[REAR]
[FLOOR/CEILING]
[AUTO] or [FLOOR]
[FLOOR/CEILING]
[AUTO] or [FLOOR]
Mounting on the ceiling and projecting forward Mounting on the ceiling and projecting from rear
(Using the translucent screen)
Menu item Setting value Menu item Setting value
[FRONT/REAR]
[FRONT]
[FRONT/REAR]
[REAR]
[FLOOR/CEILING]
[AUTO] or [CEILING]
[FLOOR/CEILING]
[AUTO] or [CEILING]
Portrait setting and projecting forward Portrait setting and projecting from rear
(Using the translucent screen)
Menu item Setting value Menu item Setting value
[FRONT/REAR]
[FRONT]
[FRONT/REAR]
[REAR]
[FLOOR/CEILING]
Set in accordance with the image
to project.
[FLOOR/CEILING]
Set in accordance with the image
to project.
Note
f
In the portrait setting, the on-screen menu is displayed sideways.
To display the on-screen menu vertically, go to the [DISPLAY OPTION] menu
→
[ON-SCREEN DISPLAY] (
x
page 99) and change the
[OSD ROTATION] setting.
f
The projector has a built-in angle sensor. The attitude of the projector is automatically detected by setting [FLOOR/CEILING] to [AUTO] in
the [PROJECTOR SETUP] menu
→
[PROJECTION METHOD].