Panasonic PT-MZ880

Chapter 3 Basic Operations — Switching on/off the projector
ENGLISH - 51
Switching on the projector
When using the optional projection lens, attach the projection lens before switching on the projector.
Remove the lens cover rst.
2)
4)
4)
3)
1)
1) Connect the power cord to the projector.
2) Connect the power plug to an outlet.
3) Press the <ON> side of the <MAIN POWER> switch to turn on the power.
f
The power indicator <ON (G)/STANDBY (R)> lights/blinks red, and the projector enters the standby mode.
4) Press the power <
v
/
b
> button.
f
The power indicator <ON (G)/STANDBY (R)> lights green and the image is soon projected on the screen.
Note
f
When the [PROJECTOR SETUP] menu
→
[ECO MANAGEMENT]
→
[STANDBY MODE] is set to [ECO], it takes longer for the projection to
start after the power is turned on, compared to when set to [NORMAL].
f
When the [PROJECTOR SETUP] menu
→
[ECO MANAGEMENT]
→
[QUICK STARTUP] is set to [ON], and the power is turned on before
the specied time elapses after the projector enters the standby mode, an image will be projected approximately one second after the power
is turned on.
The specied time is a time set in the [PROJECTOR SETUP] menu
→
[ECO MANAGEMENT]
→
[QUICK STARTUP]
→
[VALID PERIOD].
f
When the power is turned on or an input signal is switched, you may here a high-frequency driving sound. This is not a malfunction.
f
If the power was turned off at the previous use by pressing the <OFF> side of the <MAIN POWER> switch or by using the breaker directly
while projecting, the power indicator <ON (G)/STANDBY (R)> lights green and an image is projected after a while when the power is turned
on by pressing the <ON> side of the <MAIN POWER> switch or by turning the breaker on with the power plug connected to the outlet. This
applies only when the [PROJECTOR SETUP] menu
→
[INITIAL STARTUP] is set to [LAST MEMORY].