Panasonic PT-RQ22KD

Chapter 7 Appendix — Technical information
ENGLISH - 253
Control command
The following table lists the commands that can be used to control the projector using a computer.
r Projector control command
Command Details
Parameter/response
string
Remark (parameter)
PON Power on
― To check if the power is on, use the “Power query” command.
POF Power standby
QPW Power query
000
001
STANDBY
Power on
IIS
Switching the input
signal
SD1 SDI1
SD2 SDI2
SD3 SDI3
SD4 SDI4
DL1 DIGITAL LINK
AU1,SD1
*1
SDI1 [SLOT1]
AU1,SD2
*1
SDI2 [SLOT1]
AU1,SD3
*2
SDI3 [SLOT1]
AU1,SD4
*2
SDI4 [SLOT1]
AU2,SD1
*3
SDI1 [SLOT2]
AU2,SD2
*3
SDI2 [SLOT2]
AU2,SD3
*4
SDI3 [SLOT2]
AU2,SD4
*4
SDI4 [SLOT2]
AU1,HD1
*1
HDMI1 [SLOT1]
AU1,HD2
*1
HDMI2 [SLOT1]
AU2,HD3
*4
HDMI3 [SLOT2]
AU2,HD4
*4
HDMI4 [SLOT2]
AU1,DV1
*1
DVI-D1 [SLOT1]
AU1,DV2
*1
DVI-D2 [SLOT1]
AU2,DV3
*4
DVI-D3 [SLOT2]
AU2,DV4
*4
DVI-D4 [SLOT2]
OSH Shutter control 0 OPEN
QSH Shutter status query 1 CLOSE
VSE Aspect ratio switch
0 DEFAULT
1 4:3
2 16:9
5 THROUGH
QSE
Aspect ratio settings
query
6 HV FIT
9 H FIT
10 V FIT
OCS Sub memory switch
01 - 96 Sub memory number
QSB
Sub memory status
query
*1 This can be used when the optional Interface Board equipped with corresponding input is installed in <SLOT 1>.
*2 This can be used when the optional Interface Board for 12G-SDI (Model No.: ET-MDN12G10) is installed in <SLOT 1>.
*3 This can be used when the optional Interface Board for 12G-SDI (Model No.: ET-MDN12G10) is installed in <SLOT 2>.
*4 This can be used when the optional Interface Board equipped with corresponding input is installed in <SLOT 2>.
r Projector control command (with sub command)
Command Sub command Details Remark
VXX MDMI1 Execute MULTI DISPLAY
+00000 = OFF, +00001 = USER1, +00002 = USER2, +00003 = USER3
QVX MDMI1
MULTI DISPLAY MODE
query