Panasonic PT-RQ22KD

Chapter 7 Appendix — Installing the Interface Board (optional)
ENGLISH - 285
Attention
f The removed slot cover is required when the unnecessary Interface Board is removed. Store it so it can be attached in the future.
How to remove the Interface Board
Handle
Fig. 1
1) Remove the Interface Board. (Fig. 1)
f Remove the four screws xing the Interface Board by rotating counterclockwise with a Phillips screwdriver.
The removed screws are used to x the slot cover.
f Hold the handle of the Interface Board and remove it slowly.
2) Attach the slot cover.
f Attach the stored slot cover, and tighten and x with the four screws removed in Step 1).
f To replace with other Interface Board, attach the Interface Board following the procedure in “How to install
the Interface Board” (x page 284).
Attention
f Always attach the slot cover on the blank slot.
f Store the removed Interface Board inside an antistatic bag.