Panasonic PT-RQ35K

Chapter 4 Settings — [DISPLAY OPTION] menu
142 - ENGLISH
f When the [PROJECTOR SETUP] menu → [NO SIGNAL SETTING] → [BACKUP INPUT SETTING] → [BACKUP INPUT MODE] is set as
the combination to use the HDMI input, the [HDMI LINK] setting cannot be changed.
f The content set is displayed in [HDMI LINK SETTINGS].
r Structure of the projected image
The single link is a setting to display one image with one input signal. The dual link is a setting to display one
image with two input signals. The quad link is a setting to display one image with four input signals.
Dual link
HDMI1/
HDMI3
HDMI1 HDMI2
HDMI3 HDMI4
HDMI2/
HDMI4
Quad linkSingle link
Setting [SIGNAL LEVEL] in [SLOT IN] (HDMI input)
1) Press as to select [SLOT IN].
2) Press the <ENTER> button.
f The [SLOT IN] screen is displayed.
3) Press as to select [SINGLE LINK SETTING], [DUAL LINK SETTING], or [QUAD LINK SETTING], and
press the <ENTER> button.
f The [SINGLE LINK SETTING] screen, the [DUAL LINK SETTING] screen, or the [QUAD LINK SETTING]
screen is displayed.
4) Press as to select [SIGNAL LEVEL].
5) Press qw to switch the item.
f The items will switch each time you press the button.
[AUTO] Automatically sets the signal level.
[64-940]
Select this item when the signal output from the HDMI terminal of the external device (such as a
Blu-ray disc player) is input to the <HDMI IN 1> terminal, the <HDMI IN 2> terminal, the <HDMI IN 3>
terminal, or the <HDMI IN 4> terminal.
[0-1023]
Select this item when the signal output from the DVI-D terminal of the external device (such as a
computer) is input to the <HDMI IN 1> terminal, the <HDMI IN 2> terminal, the <HDMI IN 3> terminal,
or the <HDMI IN 4> terminal using a conversion cable, etc.
Select this item also when the signal output from the HDMI terminal of a computer, etc., is input to the
<HDMI IN 1> terminal, the <HDMI IN 2> terminal, the <HDMI IN 3> terminal, and the <HDMI IN 4>
terminal.
Note
f The optimal setting varies depending on the output setting of the connected external device. Refer to the operating instructions of the
external device regarding the output of the external device.
f The HDMI signal level is displayed for 30 bits of input.
Setting [AUTO GAMMA SELECT] in [SLOT IN] (HDMI input)
Set this item when the gamma mode is to be automatically set based on the InfoFrame information added to the
video signal.
1) Press as to select [SLOT IN].
2) Press the <ENTER> button.
f The [SLOT IN] screen is displayed.
3) Press as to select [OPTION SETTING].
4) Press the <ENTER> button.
f The [OPTION SETTING] screen is displayed.