Chapter 7 Appendix — Specications
ENGLISH - 309
Specications
The specications of the projector are as follows.
Display system 3-chip DLP projection system
Display device
Size of effective display
area
24.4 mm (0.96") x 3 (aspect ratio 16:10)
Number of pixels
2 304 000 pixels (1 920 x 1 200
dots)
when [QUAD PIXEL DRIVE] is set to [OFF]
9 216 000 pixels (3 840 x 2 400
dots)
when [QUAD PIXEL DRIVE] is set to [ON]
Projection lens
Supplied projection
lens
Optional
Zoom Powered
Focus Powered
Lens shift Powered (Horizontal/Vertical)
Changeable lens Yes
Light source Laser diode
Screen size
1.78 m (70") to 25.40 m (1 000")
1.78 m (70") to 15.24 m (600") with ET-D3LET80, ET-D75LE8
5.08 m (200") to 15.24 m (600") with ET-D3LEW200, ET-D3LEU100
3.05 m (120") to 15.24 m (600") with ET-D75LE95
Light output
*1*2
30 500 lm when [OPERATING MODE] is set to [NORMAL]
24 000 lm when [OPERATING MODE] is set to [ECO]
20 000 lm when [OPERATING MODE] is set to [QUIET]
Contrast ratio
*1
20 000:1 when [DYNAMIC CONTRAST] is set to [3]
Center to corner zone ratio
*1
90 %
Displayable
scanning
frequency
Horizontal
27 kHz to 135 kHz
27 kHz to 148.1 kHz
when using the optional High Frame Rate Upgrade Kit
(Model No.: ET-SUK10)
Vertical
24 Hz to 120 Hz
24 Hz to 240 Hz
when using the optional High Frame Rate Upgrade Kit
(Model No.: ET-SUK10)
*1 Measurement, measuring conditions, and method of notation all comply with ISO/IEC 21118:2020 international standards.
*2 When a projection lens other than ET-D75LE95 is used with the power supply voltage of AC 200 V.