Panasonic PT-RQ35K

Chapter 1 Preparation — About your projector
36 - ENGLISH
Names and functions of the Interface Board (optional)
This projector is equipped with two SLOT NX-specication slots.
The input for HDMI, DVI-D, and SDI can be added by installing the optional Interface Board in the slot.
Attention
f Requesting a qualied technician to install or remove the Interface Board is recommended. A malfunction may occur due to static electricity.
Consult your dealer.
Interface Board for HDMI 2 input (Model No.: ET-MDNHM10)
This board supports the HDMI signal.
13 32
1 <HDMI IN 1> terminal (when installed in <SLOT 1>), <HDMI
IN 3> terminal (when installed in <SLOT 2>)
This is a terminal to input HDMI signal.
2 <HDMI IN 2> terminal (when installed in <SLOT 1>), <HDMI
IN 4> terminal (when installed in <SLOT 2>)
This is a terminal to input HDMI signal.
3 Handle
Note
f When performing the simultaneous input of the 4K image (resolution of 3 840 x 2 160 or 4 096 x 2 160) using the Interface Board for HDMI
2 input (Model No.: ET-MDNHM10), it is necessary for the rmware version of the Interface Board for HDMI 2 input to be 2.00 or later. If the
version is earlier than 2.00, the simultaneous process is not performed even if corresponding signal is input. Consult your dealer regarding
the version update to the latest rmware.
For details on how to conrm the rmware version, refer to “How to conrm the rmware version of the Interface Board (optional)”
(x page 38).
Interface Board for DVI-D 2 input (Model No.: ET-MDNDV10)
This board supports the DVI-D signal.
13 32
1 <DVI-D IN 1> terminal (when installed in <SLOT 1>), <DVI-D
IN 3> terminal (when installed in <SLOT 2>)
This is a terminal to input DVI-D signal.
2 <DVI-D IN 2> terminal (when installed in <SLOT 1>), <DVI-D
IN 4> terminal (when installed in <SLOT 2>)
This is a terminal to input DVI-D signal.
3 Handle
Interface Board for DisplayPort 2 input (Model No.: ET-MDNDP10)
This board supports the DisplayPort signal.
13 32
1 <DisplayPort IN 1> terminal (when installed in <SLOT 1>),
<DisplayPort IN 3> terminal (when installed in <SLOT 2>)
This is a terminal to input DisplayPort signal.
2 <DisplayPort IN 2> terminal (when installed in <SLOT 1>),
<DisplayPort IN 4> terminal (when installed in <SLOT 2>)
This is a terminal to input DisplayPort signal.
3 Handle