Panasonic PT-RQ35K

Chapter 7 Appendix — Technical information
300 - ENGLISH
r ENABLE/DISABLE
Operation for all channels is not accepted when set to “Disable”.
Performance Parameter Default value
Disable 0-127
0
Enable 128-255
Note
f If the projector is operated using the remote control or the control panel, or by the control command while controlling the projector using the
Art-Net function, the setting of the DMX controller or computer application may be different from the projector status. To reect the controls
of all channels to the projector, set “ENABLE/DISABLE” of channel 11 to “Disable” and then back to “Enable”.
f To create and register the USER LOGO image, use “Logo Transfer Software”. The software can be downloaded from the Panasonic website
(https://panasonic.net/cns/projector/).
Control commands via LAN
The projector can be controlled via the <DIGITAL LINK> terminal or the <LAN> terminal by using the control
command format via the <SERIAL IN> terminal.
For examples of the available commands, refer to “Control command” (x page 307).
Note
f To send/receive the command via LAN, it is necessary to set the password of the administrator account. (x page 220)
When connecting in protect mode
Connecting
Following is the connection method when the [NETWORK] menu → [NETWORK SECURITY] → [COMMAND
PROTECT] is set to [ENABLE].
1) Obtain the IP address and port number (Initial set value = 1024) of the projector and request a
connection to the projector.
f You can obtain both the IP address and the port number from the menu screen of the projector.
IP address
Obtain from the [NETWORK] menu → [NETWORK STATUS].
Port number
Obtain from the [NETWORK] menu → [NETWORK CONTROL] → [COMMAND PORT].
2) Check the response from the projector.
Data section Blank Mode Blank Random number section
Termination
symbol
Command
example
“NTCONTROL”
(ASCII string)
‘ ’
0x20
‘1’
0x31
‘ ’
0x20
“zzzzzzzz”
(ASCII code hex number)
(CR)
0x0d
Data length 9 bytes 1 byte 1 byte 1 byte 8 bytes 1 byte
f Mode: 1 = Protect mode
f Example: Response during protect mode (random number section is undened value)
“NTCONTROL 1 23181e1e” (CR)
3) Generate a 32-byte hash value from the following data using MD5 algorithm.
f “xxxxxx:yyyyy:zzzzzzzz”
xxxxxx The user name for the administrator account
yyyyy The password for the administrator account
zzzzzzzz 8-byte random number obtained in Step 2)