Panasonic PT-RQ35K

Chapter 4 Settings — [NETWORK] menu
ENGLISH - 223
12) After the password is entered, press asqw to select [OK], and press the <ENTER> button.
f The [PJLink PASSWORD] screen is displayed.
13) Press as to select [STORE], and press the <ENTER> button.
f The conrmation screen is displayed.
14) Press qw to select [OK], and press the <ENTER> button.
Note
f The PJLink password can also be changed in “[Set up password] page (when accessed by administrator account)” (x page 258) of the
web control screen.
[PJLink CONTROL]
Enable/disable the control function using PJLink protocol.
1) Press as to select [PJLink].
2) Press the <ENTER> button.
f The [PJLink] screen is displayed.
3) Press as to select [PJLink CONTROL].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[ON] Select this item when controlling projectors with the PJLink protocol.
[OFF] Select this item when not controlling projectors with the PJLink protocol.
[PJLink NOTIFICATION]
Enable/disable the notication function of the PJLink.
1) Press as to select [PJLink].
2) Press the <ENTER> button.
f The [PJLink] screen is displayed.
3) Press as to select [PJLink NOTIFICATION].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF] Select this item when not using the notication function of the PJLink.
[ON] Select this item when using the notication function of the PJLink.
f Proceed to Step 5) when [ON] is selected.
5) Press as to select [NOTIFIED IP ADDRESS 1] or [NOTIFIED IP ADDRESS 2].
f Enter the IP address of the computer to be notied of the status of the projector.
[Art-Net]
Set the Art-Net function.
f To use the Art-Net function with the projector, it is necessary to set the password of the administrator account.
(x page 220)
Note
f When a password is not set for the administrator account (when blank), the network function of the projector cannot be used. When using
the web control function or the communication control via LAN (including operation by application software), set a password.
[Art-Net SETUP]
Make settings to use the Art-Net function.
1) Press as to select [Art-Net].