Chapter 3 Basic Operations — Switching on/off the projector
ENGLISH - 75
Relationship between brightness and runtime
The projector can be operated with arbitrary brightness and runtime by setting [LIGHT OUTPUT] to desired
setting.
The relationship between the [LIGHT OUTPUT] setting, brightness, and the estimated runtime is as follows. Make
the initial setting (operation setting) depending on the desired brightness of the projected image and runtime.
The values of the brightness and the runtime are just an estimate, and the graph indicating the relationship is just
an example. Also, these do not indicate the warranty period.
[LIGHT OUTPUT] (%) Brightness (lm) Estimated runtime
*1
(hours)
100.0 30 500 25 500
80.0 24 000 37 000
70.0 21 000 44 000
60.0 18 000 52 000
50.0 15 000 61 500
*1 Estimated runtime is the time until the brightness decreases to approximately half of the time of delivery when the projector is used with the
[PICTURE] menu → [DYNAMIC CONTRAST] set to [3] and under environment of 0.15 mg/m
3
dust.
Estimated runtime (hours)
61 50054 30047 10039 90032 70025 500
40.0
15 000
50.0
60.0
[LIGHT OUTPUT] (%)
Brightness (lm)
70.0
80.0
90.0
100.0
30 500
Note
f Under inuence of characteristics of each light source, conditions of use, installation environment, etc., the runtime may be shorter than the
estimation.
f If the consolidated runtime of the projector exceeds 20 000 hours, replacement of the components inside the projector may be required. The
consolidated runtime can be conrmed in the [STATUS] screen. Refer to the [PROJECTOR SETUP] menu → [STATUS] for details.
f After completed the initial setting, the wider the combination of luminance and runtime becomes by setting the [PROJECTOR SETUP]
menu → [BRIGHTNESS CONTROL] → [BRIGHTNESS CONTROL SETUP] → [CONSTANT MODE] to [AUTO] or [PC]. Refer to the
[PROJECTOR SETUP] menu → [BRIGHTNESS CONTROL] for details.
Initial setting (installation setting)
Set [FRONT/REAR] and [FLOOR/CEILING] in [PROJECTION METHOD] depending on the installation mode.
Refer to “Installation mode” (x page 42) for details.
After completed the initial setting, you can change the setting from the [PROJECTOR SETUP] menu →
[PROJECTION METHOD].
1) Press qw to switch the setting.
ENTER
SET
CHANGE
Change the projection method (FRONT/REAR,
FLOOR/CEILING) if the screen display is upside down
or inverted.
PROJECTION METHOD
INITIAL SETTING
FRONT/REAR
FLOOR/CEILING
MENU SELECT
FRONT
AUTO
3/6
2) Press the <ENTER> button to proceed to the initial setting.
To Next Page
Loading...
