2.10.1. Greasing for Heat-pipe unit
1. Set a LD GREASE MASK PLATE on a Heat-pipe unit by clips as shown below.
2. Paint the grease on the Heat-pipe unit by spatula.
3. Remove the LD GREASE MASK PLATE.
LD GREASE MASK PLATE
Heat-pipe unit
Please make sure that the boss of
the Heat-pipe is fitted into the
hole of the plate.
Clip
Clip
Please make sure that the plate is
flat and attached to the Heat-pipe.
Heat-pipe unit
Paint the grease over the entire
surface of orange area of heat-pipe
Paint the grease on the heat-pipe with
the same thickness as the plate.
Heat-pipe unit
LD GREASE
MASK PLATE
DIS-16
To Next Page
Loading...
