Panasonic PT-VW360

Control commands
When controlling the projector from a computer, the following commands are available.
r Projector control command
Command Control Details
Parameter/response
string
Remark (parameter)
PON Power on
―
To check if the power is on, use the “Power query” command.
POF Power standby
QPW Power query
000
001
STANDBY
Power on
IIS
Switching the input
signal
VID VIDEO
RG1 COMPUTER1
RG2 COMPUTER2
HD1 HDMI1
HD2 HDMI2
NWP NETWORK
UD1 USB DISPLAY
MV1 MEMORY VIEWER
AUU Volume up
― ―
AUD Volume down
Q$L
Luminous lamp
cumulative runtime
query
1 Returned with 0 to 99999
OSH AV mute control 0 AV mute function off
QSH AV mute status query 1 AV mute function on
Q$S
Luminous lamp
condition query
0
1
2
3
Stand-by
Luminous lamp ON control active
Luminous lamp ON
Luminous lamp OFF control active
VSE Aspect ratio switch
0 AUTO
1 NORMAL
2 WIDE
5 NATIVE
QS1
Aspect ratio settings
query
6 FULL
9 H FIT
10 V FIT
r Projector control command (with sub command)
Command Sub command Details Remark
VXX RYCI1 COMPUTER1 input setting +00000=RGB/YP
B
P
R
, +00001=Y/C
[MENU LOCK PASSWORD] operations
To initialize your password, consult your distributor.
ENGLISH - 127
Chapter 7 Appendix - Technical Information