Panasonic PT-VW360

1) Press as to select [SXGA MODE].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[AUTO] Displays by judging the signal automatically. Set to this mode normally.
[1280x1024]
Switches the item to [1280x1024] or [1400x1050] manually if the whole projected image is not displayed when
SXGA signal is input.
[1400x1050]
[P-TIMER]
Set and operate the presentation timer function.
1) Press as to select [P-TIMER].
2) Press the <ENTER> button.
f The [P-TIMER] screen is displayed.
[MODE] Switches the elapsed time between [COUNT UP] and [COUNT DOWN].
[TIMER] Sets the nish time of timer when [COUNT DOWN] is selected.
[START] / [STOP] /
[RESTART]
Operates the timer.
[RESET] Resets the count.
[EXIT] The presentation timer function is ended.
Setting [MODE]
1) Press as to select [MODE].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[COUNT UP] Displays the elapsed time since the count was started.
[COUNT DOWN] Displays the remaining time of the time set by [TIMER].
Setting the countdown timer
1) Press as to select [TIMER].
2) Press qw to set the timer.
f The time can be set in 1-minute increments from 1 to 180 minutes.
f The factory default value is 10 minutes.
Note
f [TIMER] is available only when [MODE] is set to [COUNT DOWN].
The operation of [P-TIMER]
1) Press as to select one item.
[START] The count is started.
[STOP] The count is stopped.
[RESTART] The count is resumed.
[RESET] The count is reset.
2) Press the <ENTER> button.
f When you select [START] or [RESTART], the remaining time or the elapsed time will be displayed in the
lower right of the projected image.
f When you select [STOP], the remaining time or the elapsed time while stopping the counting will be
displayed in the lower right of the projected image.
Note
f You can also use the P-TIMER function by pressing the <P-TIMER> button on the remote control (x page 48).
f If the elapsed time or remaining time is displaying, the text will not be displayed even when the [SECURITY] menu → [TEXT DISPLAY]
(x page 82) is set to [ON].
f The elapsed time or remaining time will not be displayed when the menu screen is displaying.
72 - ENGLISH
Chapter 4 Settings - [DISPLAY OPTION] menu