1) Press as to select [HIGH ALTITUDE MODE].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF] Select when using the projector in the elevation of below 1 400 m (4 593').
[HIGH1] Select when using the projector in the elevation of above 1 400 m (4 593') and below 2 000 m (6 562′).
[HIGH2] Select when using the projector in the elevation of above 2 000 m (6 562′) and below 2 700 m (8 858′).
Note
f It is set to [OFF] when using the projector in the elevation of below 1 400 m (4 593'). It is set to [HIGH1] when using the projector in the
elevation of above 1 400 m (4 593') and below 2 000 m (6 562′). It is set to [HIGH2] when using the projector in the elevation of above 2 000
m (6 562′) and below 2 700 m (8 858′). Failure to do so may shorten the life of the internal parts and result in malfunctions.
f Do not set the projector in the elevation of 2 700 m (8 858′) or above, otherwise it may shorten the life of the internal parts and result in
malfunctions.
f When it is set to [HIGH1] or [HIGH2], the fan noise becomes louder and fan speed increases.
[LAMP POWER]
Switch the luminance of the luminous lamp according to the operating environment of the projector or the
purpose.
1) Press as to select [LAMP POWER].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[NORMAL] Select when high luminance is required.
[ECO] Select when high luminance is not required.
Note
f The projector can consume less power, extend the luminous lamp life longer and produce less operation noise when set from [NORMAL] to
[ECO].
[ECO MANAGEMENT]
This function optimizes the luminous lamp power according to the operating status and reduces power
consumption.
1) Press as to select [ECO MANAGEMENT].
2) Press the <ENTER> button.
f The [ECO MANAGEMENT] screen is displayed.
3) Press as to select one item.
Setting [AUTO POWER SAVE] in Step 3)
Set whether or not to enable the three functions, [AMBIENT LIGHT DETECTION], [SIGNAL DETECTION] and [AV
MUTE DETECTION].
Note
f [AUTO POWER SAVE] cannot be set when the [LAMP POWER] is set to [ECO].
4) Press qw to switch the [AUTO POWER SAVE].
[ON] Enables power-saving mode.
[OFF] Disables power-saving mode.
5) Press as to select one item.
[AMBIENT LIGHT DETECTION] Adjusts the luminous lamp power according to the ambient brightness.
[SIGNAL DETECTION] Drops the luminous lamp power when no signal is input.
[AV MUTE DETECTION] Drops the luminous lamp power in the AV mute mode.
6) Press qw to switch the item.
76 - ENGLISH
Chapter 4 Settings - [PROJECTOR SETUP] menu
To Next Page
Loading...
