4) Select [OK] with the as buttons and press the <ENTER> button.
f To cancel the change of the name, select [CANCEL] and press the <ENTER> button.
Note
f [Name □□□□] (□□□□ is 4-digit number) is set before the projector leaves the factory.
[NETWORK CONTROL]
Set when you want to control the projector from a computer connected to the network.
1) Press as to select [NETWORK CONTROL].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[ON] This function is enabled. Web control, PJLink control, and the command control of the LAN are enabled.
[OFF] This function is disabled.
[AMX D.D.]
Set to [ON] to control with the controller of AMX Corporation.
Setting this function to [ON] enables detection through “AMX Device Discovery”. For details, refer to the website
of AMX Corporation.
URL http://www.amx.com/
1) Press as to select [AMX D.D.].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF] This function is disabled.
[ON] This function is enabled.
[Crestron Connected(TM)]
Set to [ON] to control with Crestron Connected™ of Crestron Electronics, Inc.
1) Press as to select [Crestron Connected(TM)].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF] This function is disabled.
[ON] This function is enabled.
[MEMORY VIEWER LIGHT]
Set the operations of the Memory Viewer Light function.
Note
f The [MEMORY VIEWER LIGHT] menu can be operated and set only when MEMORY VEWER input is selected.
f For details on how to use the memory viewer function, please refer to "Memory Viewer function" (x page 87).
[SET SLIDE]
Start the slideshow. For details on the slideshow, see "Executing the slide" (x page 88).
[SLIDE TRANSITION EFFECT]
Sets the transition effects when switching the slides playback.
1) Press as to select [SLIDE TRANSITION EFFECT].
2) Press qw to switch the item.
f The items will switch each time you press the button.
ENGLISH - 83
Chapter 4 Settings - [NETWORK/USB] menu
To Next Page
Loading...
