Panasonic S-3650PF3E - Page 239

5-2-1-10
5
E09 More Than One Remote Controller Set to Main Error
Error Detection Method
Error Diagnosis
It is judged an error when more than one remote controller in a remote control group is set as the main remote controller.
Forgot to set one remote controller to sub in a 2-remote control group.
When using one wireless and one wired remote controller in a control group, forgot to set one of them to sub.
•
•
Method for setting a remote controller to sub
<CZ-RTC4>
•
1.
2.
Set one of the 2 remote controllers to sub.1-1
1 Remote
controller
Press and hold + buttons for several seconds simultaneously..
Press button (Once the display changes from flashing to steady, the setting is complete).
Once you press button, the remote controller returns to its normal display.
This will display , the CODE No. “01” and the SET DATA “0001” or the like on the remote controller’s display.
Press
1.
5.
6.
2.
3. / buttons to select the CODE No. to “01”.
Wireless remote controller
CZ-RWRU3
CZ-RWRC3
ScrewPCB cover
Receiver PCB
Address switch
(1 – 3)
1 2 3 4
ON
Main/Sub setting
Use this to set Main/Sub for the remote controller and the receiver.
Set one to [Main] and the other to [Sub].
Factory default: [Main]
It is recommended to set the wired remote controller to [Main].
BUSNIAMbuS/niaM
Main/Sub switch position
1 2 3 4
1 2 3 4
A
Press4. / buttons to select the SET DATA to “0000”. (0000: Sub 0001: Main)
<CZ-RTC5B>
Press and hold + + buttons for 4 seconds or more simultaneously.
Press button. After selecting [YES], the unit restarts.
The Code no. “01” and the Set data “0001” or the like on the remote controller’s display.
1.
6.
3.
Press2. / buttons to select the “3. RC. setting mode” and press the button.
Press4. / buttons to select the Code no. to “01” and press the button.
Press5. / buttons to select the Set data to “0000” (0000: Sub 0001: Main) and press the button.
1 2 3 4
Factory default:
OFF (1 – 4)
Factory default:
OFF (1 – 4)
Main/Sub
switch (4)*
OFF: Main
ON: Sub
Address switch (1 – 3)
Switch
Main/Sub
switch (4)*
OFF: Main
ON: Sub
When using the infrared remote controller and the wired remote controller in combination,
set the wired remote controller to [Main].
*
SM830283-00_欧州向け R32シングル36-71形TD&SM.indb 10 2020/01/29 21:17:46