Panasonic SA-PM91DEE

Abnormal display The error is detailed
F506 Media cannot distinguish. (It is invalid media.)
F600 Administrative information cannot be acquired by the recovery error.
F601 Irregular sector ID demand
F602 LEAD-IN information cannot be acquired by the recovery error.
F603 KEY_DET cannot be acquired by the recovery error.
F610 ODC loss of control
F611 CRCOK doesn´t go out during the fixed time. (CD system)
F612 CRCOK doesn´t go out during the fixed time. (DVD system)
F620 Laser protection"State of high temperature"
F621 Laser protection"State of circuit breakdown"
F700 MBX Overflow
F701 Message Command Not Complete Error
F702 Message Command Changed
F880 The task number is inapposite.
F890 It tried to transmit the message while transmitting to the AV task.
F891 The message to the AV task was not able to transmit. (mailbox overflow etc.)
F8A0 The message command is inapposite.
F893 Flash ROM is falsified.
F894 EEPROM, it is not normal.
F895 The language destination is abnormal.
F896 It is a model setting that doesn´t exist.
F897 Cannot it written and the following initialization been done.
F0BB DVD-R cannot reproduce.
F0BC DVD-RAM cannot reproduce.
F0BD CD-R cannot reproduce. Reservation..display.
F0BE CD-RW cannot reproduce. Reservation..display.
F0BF Because a physical layer cannot distinguish, it is not possible to reproduce.
F0C0 It is not DVD Video but it cannot be a reproduction.
F0C1 It prohibits it for the prohibition region code.
F0C2 Reproduction prohibition of PAL
F0C3 All title reproduction prohibition of Parental setting
F0C4 Because it is PHOTO CD format, it prohibits it.
F0C5 Because it is CDROM without VCD/CD:CD-DA, it prohibits it.
F0D0 Length error of retrieved file name
F0D1 Retrieved file or directory was not found.
F630 Non-response to KEY_DET inquiry (It is not CPPM-DISC.)
F631 Even the FILE terminal cannot have done CPPM_KEY_DET.
F632 CPPM_KEY_DET cannot have been done.
9312 ADR is not one.
9F20 OUT of PB AREA
9F30 DATA Track PLAY
9F40 Media type decision (It is data among the drive managers.)
14.7. Service Mode Table 2
Following modes are available with combinations of the pressed buttons on the player and on the remote controller unit.
Item Operational Condition
and Key Function
Details Display To Exit Mode
Error code display While the player is
stopped and no disc is
inserted, press and
hold down the [STOP]
button on the player
and the number
button, “0” on the
remote controller unit.
Error code display
Displays the latest error code stored in
EEPROM.
[DVD_---]
*---: Error number
Automatically exits
the mode after five
seconds.
ADSC internal RAM
display
While the player is
stopped and no disc is
inserted, press and
hold down the [STOP]
button on the player
and the number button
“1” or “2” on the remote
controller unit.
ADSC internal RAM display
Reads and displays the RAM value
inside ADSC. The address is renewed
when the CLEAR key is pressed so
that the values at eleven points appear.
[xxx _DDDD_A]
A :ADSC internal RAM display
mode
xxx : Address
DDDD : RAM value at displayed
address
Values are shown in the
hexadecimal digit. The above
example indicates that ADSC value
at the address, xxx is DDDD.
Press the STOP.
59
SA-PM91DEE