Panasonic SDR-S9 - Page 26

26
VQT1P61
Setup
2 Close the LCD monitor while
the mode dial is set to or
.
The status indicator A flashes green and
the unit goes into quick start standby
mode.
3 Open the LCD monitor.
The status indicator A lights red and the
unit is put into recording pause approx.
1.7 seconds after it is turned on.
To cancel Quick start
Press the MENU button then [SETUP]
#
[QUICK START] # [OFF] and then
press the cursor button in the centre.
≥ The status indicator goes off and the
power turns off if the mode dial is set to
OFF while the unit is in quick start
standby mode.
≥ The status indicator goes off and the
power turns off if quick start standby
mode continues for approx. 5 minutes.
≥ Quick start standby mode is cancelled,
the status indicator goes off and the
power turns off in the following cases.
jWhen the mode dial is switched.
≥ When this unit is quick-started with the
white balance on automatic, it may
take some time until the white balance
is adjusted if the scene being recorded
has a light source different from the
scene last recorded. (When the Colour
night view function is used, however,
the white balance of the scene last
recorded is retained.)
≥ When this unit is quick-started, the
zoom magnification becomes 1k and
the view may differ from what it was
before quick start standby mode.
≥ If [POWER SAVE] is set to
[5 MINUTES] and the unit
automatically goes into quick start
standby mode, close the LCD monitor
and then open it again.
A
A
SDR-S9-VQT1P61_eng.book 26 ページ ２００７年１２月１８日 火曜日 午後３時５９分