35
VQT1P61
Setup
To get back to the previous
screen
Press the cursor button left.
To exit the menu screen
Press the MENU button.
≥ The menu screen does not appear
during recording or playing. You
cannot start other operations while the
menu screen appears.
Setting date and time
When the unit is turned on for the first
time, a message asking you to set the
date and time will appear.
≥ Select [YES] and press the cursor
button in the centre. Perform steps 2
and 3 below to set the date and time.
If the screen shows the incorrect date
and time, then adjust it.
¬Rotate the mode dial to select
or .
1 Press the MENU button, then
select [BASIC] #
[CLOCK SET] # [YES] and
then press the cursor button
in the centre.
2 Press the cursor button left or
right to select the item to be
set. Then, press the button up
or down to set the desired
value.
≥ The year will change as follows:
2000, 2001, ..., 2099, 2000, ...
≥ The 24-hour system is used to
display the time.
2008 1211 34
SDR-S9-VQT1P61_eng.book 35 ページ ２００７年１２月１８日 火曜日 午後３時５９分
To Next Page
Loading...
