Panasonic SDR-S9 - Page 77

77
VQT1P61
With other products
9 Select the layout setting on
[PAGE LAYOUT].
≥ You cannot set page layouts not
supported on the printer.
10Select [PRINT] # [YES] and
then press the cursor button
in the centre.
The pictures are printed.
≥ Exit PictBridge by disconnecting
the USB cable after the pictures
have been printed.
When you want to stop printing
halfway
Press the cursor button down.
A confirmation message appears. If
[YES] is selected, the number of prints
set is cancelled and the screen returns to
step 4. If [NO] is selected, all the settings
are kept and the screen returns to
step 4.
≥ Avoid the following operations during
printing. These operations disable
proper printing.
jDisconnecting the USB cable
jOpening the card/battery door
jSwitching the mode dial
jTurning off the power
≥ Check the settings for the paper size,
quality of print, etc. on the printer.
≥ You may not be able to print still
pictures recorded with other products.
≥ When the unit is connected directly to
the printer, the DPOF settings cannot
be used.
≥ Connect the printer directly to this unit.
Do not use a USB hub.
[STANDARD]: Layout specific to the
printer
[]: No frame print
[]: Frame print
SDR-S9-VQT1P61_eng.book 77 ページ ２００７年１２月１８日 火曜日 午後３時５９分