[NETWORK] menu
On the menu screen, select [NETWORK] from the main menu, and select an item from the submenu.
Refer to “Navigating through the menu” (x page 65) for the operation of the menu screen.
f To use the wireless LAN function with the projector, it is necessary to attach the optional Wireless Module
(Model No.: AJ-WM50).
[ETHERNET TYPE]
(Not available for PT-VMZ51S and PT-VMZ41)
Set the path for transmitting the Ethernet signal.
1) Press as to select [ETHERNET TYPE].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[LAN] Select this item when using only the <LAN> terminal to transmit the Ethernet signal.
[DIGITAL LINK] Select this item when using only the <DIGITAL LINK/LAN> terminal to transmit the Ethernet signal.
[LAN & DIGITAL LINK]
Select this item when using the <DIGITAL LINK/LAN> terminal and the <LAN> terminal to transmit
the Ethernet signal.
Note
f When [ETHERNET TYPE] is set to [LAN], the Ethernet and serial control signals cannot be transmitted via the optional DIGITAL LINK output
supported device (Model No.: ET-YFB100G, ET-YFB200G) connected to the <DIGITAL LINK/LAN> terminal.
f When [ETHERNET TYPE] is set to [LAN & DIGITAL LINK], the <DIGITAL LINK/LAN> terminal and the <LAN> terminal are connected inside
the projector. Do not directly connect the <DIGITAL LINK/LAN> terminal and the <LAN> terminal using a LAN cable. Construct the system
so that it is not connected to the same network via the peripherals such as the switching hub or the twisted-pair-cable transmitter.
[DIGITAL LINK]
(Not available for PT-VMZ51S and PT-VMZ41)
Make settings and operations related to DIGITAL LINK.
[DIGITAL LINK MODE]
Switch the communication method of the <DIGITAL LINK/LAN> terminal of the projector.
1) Press as to select [DIGITAL LINK].
2) Press the <ENTER> button.
f The [DIGITAL LINK] screen is displayed.
3) Press as to select [DIGITAL LINK MODE].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[AUTO]
Switches the communication method automatically to DIGITAL LINK, long reach or Ethernet.
[DIGITAL LINK]
Fixes the communication method to DIGITAL LINK.
[LONG REACH]
Fixes the communication method to long reach.
[ETHERNET]
Fixes the communication method to Ethernet.
Possible communication modes
l: Communication possible
―: Communication not possible
Setting
Communication possibility
Image transfer
(100 m (328'1"))
Image transfer
(150 m (492'2"))
Ethernet RS-232C
[AUTO]
For DIGITAL LINK
l
―
l l
For long reach
―
l l l
For Ethernet
― ―
l
*1
―
ENGLISH - 103
Chapter 4 Settings - [NETWORK] menu
To Next Page
Loading...
