Note
f The PJLink password can also be changed on the [Set up password] page (x page 137) of the web control screen.
[PJLink CONTROL]
Set to enable or disable the PJLink protocol control function.
1) Press as to select [PJLink].
2) Press the <ENTER> button.
f The [PJLink] screen is displayed.
3) Press as to select [PJLink CONTROL].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[ON]
Enables PJLink protocol control function.
[OFF]
Disables PJLink protocol control function.
[PJLink NOTIFICATION]
Set to enable or disable the PJLink notication function.
1) Press as to select [PJLink].
2) Press the <ENTER> button.
f The [PJLink] screen is displayed.
3) Press as to select [PJLink NOTIFICATION].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
Disables the PJLink notication function.
[ON]
Enables the PJLink notication function.
f If [ON] is selected, proceed to Step 5).
5) Press as to select [NOTIFIED IP ADDRESS 1] or [NOTIFIED IP ADDRESS 2], and press the <ENTER>
button.
f The [NOTIFIED IP ADDRESS 1] screen or the [NOTIFIED IP ADDRESS 2] screen is displayed.
f Enter the IP address of the computer to notify the status of the projector.
6) After entering the IP address, press asqw to select [OK], and press the <ENTER> button.
[MEMORY VIEWER]
Set the operations of the Memory Viewer function.
Note
f The [MEMORY VIEWER] menu can be operated and set only when MEMORY VIEWER input is selected.
f For details on how to use the memory viewer function, please refer to “Projecting with MEMORY VIEWER input” (x page 115).
[SET SLIDE]
Start the slideshow. For details on the slideshow, see “Executing the slide” (x page 116).
[SLIDE TRANSITION EFFECT]
Sets the transition effects when switching the slides playback.
1) Press as to select [SLIDE TRANSITION EFFECT].
2) Press qw to switch the item.
f The items will switch each time you press the button.
ENGLISH - 111
Chapter 4 Settings - [NETWORK] menu
To Next Page
Loading...
